Keithley 2606B System SourceMeter, Справочное руководство, Страница: 540 / 756

Section 7: TSP command reference 2606B System SourceMeter® Instrument Reference Manual
7-256 2606B-901-01 Rev. B / May 2018
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to Status register set
contents (on page E-1) and Enable and transition registers (on page E-16). The individual bits of this
register are defined in the following table.
Bit Value Description
B0
Not used Not applicable.
B1
status.measurement.current_limit.SMUA Set bit indicates that the SMU A current
limit was exceeded.
Bit B1 decimal value: 2
Binary value: 0000 0010
B2
status.measurement.current_limit.SMUB
Set bit indicates that the SMU B current
limit was exceeded.
Bit B2 decimal value: 4
Binary value: 0000 0100
B3-B15
Not used Not applicable.
As an example, to set bit B1 of the measurement event current limit summary enable register, set
status.measurement.current_limit.enable =
status.measurement.current_limit.SMUA
.
In addition to the above constants,
measurementRegister
can be set to the decimal equivalent of
the bit to set. To set more than one bit of the register, set
measurementRegister
to the sum of
their decimal weights. For example, to set bits B1 and B2, set
measurementRegister
to 6 (which is
the sum of 2 + 4).
Example
status.measurement.current_limit.enable = status.measurement.current_limit.SMUA
Sets the SMUA bit of the Measurement Event Current Limit Summary Enable Register.
Also see
Measurement event registers (on page E-21)
status.measurement.instrument.smuX.* (on page 7-258)