IBM i 830, Руководство по ремонту

Страница: 654 / 1000

1. Install the card in to the system by reversing the card removal procedure
above.
2.
Select the Power on domain option for the IOA or IOP that you are installing.
Note: To the right of the description field you will see one or both of the
following symbols displayed:
*
>
The * indicates the location to which the system will assign the resource.
Where as the > indicates the location to which the resource was last
assigned.
3.
Press enter, the “ Work with Controlling Resources ” screen will appear.
4. Determine the location where you want to assign the resource and select the
assign to option for that location.
5.
Wait for the
″
Hardware Resource Concurrent Maintenance
″
display to appear with
the message indicating power on complete.
6. After exchanging the failing item, then go to “Verifying the Repair” on
page 920.
Note: If you have exchanged a 2766 Fibre Channel IOA, the IBM 2105 disk unit
subsystem must be updated to use the World-Wide Port-Name of the
new 2766 IOA. This name can be found in the Port worldwide name
field on the iSeries 400 by displaying detail on the 2766 IOA Logical
Hardware Resource information in Hardware Service Manager in
SST/DST. The 16-digit World-Wide Port-Name can also be determined
by including the digits
″
1000
″
to the beginning of the 12-digit IEEE
Address found on the tailstock label of the Fibre Channel IOA. Use the
ESS Web Interface User’s Guide (SC26–7346) to update the World-Wide
Port-Name in the host configuration on the IBM 2105 ESS. The ESS Web
Interface User’s Guide can also be found at the following URL:
http://www.storage.ibm.com/hardsoft/products/ess/refinfo
This ends the procedure.
This ends the procedure.
FC 5075 – Cards – Dedicated
v
Card positions C01 through C08 permit concurrent maintenance using HSM. You
can power down the individual card slot or the FC 5075 Tower. See “FC 5075 –
Cards – Concurrent” on page 638.
v
All other card positions permit concurrent maintenance using HSM. You can
NOT power down the individual card slot. You can power down the FC 5075
Tower. See “FC 5075 – Cards – Concurrent” on page 638.
Attention: All cards are sensitive to electrostatic discharge (see “Appendix C.
Working with Electrostatic Discharge-Sensitive Parts” on page 955).
CAUTION:
The circuit card contains lead solder. To avoid the release of lead (Pb) into the
environment, do not burn. Discard the circuit card as instructed by local
regulations. (RSFTC234)
Remove and Replace Procedures
640
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1