IBM i 830, Руководство по ремонту

Страница: 302 / 1000

v
Select option
″
Display partition information
″
.
v
Select option
″
Display allocated I/O resources
″
.
v
Page down until you find the console IOP for the partition that you are
working with.
v
Select function
″
Display logical address
″
.
v
Record the bus, card and board logical address for the console’s IOP.
v
Go to HSM in the Primary partition.
v
Select option
″
Logical hardware resources
″
.
v
Select option
″
System bus resources
″
.
v
Select option
″
Display detail
″
for each System Bus on the
″
Logical Hardware
Resources on System Bus
″
display until you find the bus with the same bus
number you recorded for the IOP.
v
For the system bus that you found, select option
″
Associated packaging
resource(s)
″
.
v
Record the frame ID in the
″
Frame ID
″
column.
6. Record the frame type/feature by using the frame ID and system
configuration listing OR locate the frame with that ID and record the frame
type/feature.
7. Is the bus number that you recorded for the IOP between 4 and 23 (in
decimal) ?
Yes No
↓
Go to step 9 of this procedure.
8.
Perform
″
BUS PIP CNSL01
″
in the Migrated Expansion Tower Problem Analysis,
Repair and Parts .
This ends the procedure.
9. Determine the card location of the IOP by going to the bus overview section
of this document and locate the card position table for the frame type/feature
you recorded using the bus and card logical address you recorded. Follow the
page reference given at the end of this step. Record the card location for the
IOP. Follow this page reference for the Bus “Overview” on page 279 section of
this book.
10.
Exchange the IOP in that card position by performing the following:
a. Refer to the
″
Locations, Addresses and Part Listings
″
section of this
document. The page reference is given in step 10e.
b.
Within the
″
Locations, Addresses and Part Listings
″
section go to the
section for the frame type/feature that you recorded.
c. Go to the
″
FRU Locations and Failing Items table
″
for the frame
type/feature that you recorded.
d. Locate the card position in the
″
FRU Locations and Failing Items table
″
and use the
″
Removal and Installation Procedure
″
identified for that card
location.
e. Follow this reference for the “Locations and Addresses” on page 705.
Power on the secondary partition.
This ends the procedure.
11. The problem is in the Primary partition of a system with one or more
partitions.
12.
The console IOP is in the Base I/O tower for the system unit. Exchange the
IOP in card position C01.
Bus, High-Speed Link (HSL) PIPs
288
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1