IBM i 830, Руководство по ремонту

Страница: 552 / 1000

address of the I/O Adapter. See “SRC Address Formats” on page 936. Use the
address to find the location. See “Locations and Addresses” on page 705.
This ends the procedure.
FCPORT
The Fibre Channel IOA port may be the failing item.
Perform the following:
1. Is the SRC 2765/2766 3120 or has a 2765/2766 3120 SRC been logged within 5
minutes of the SRC that sent you to this symbolic FRU?
Yes No
↓
The Fibre Channel IOA port has not failed. See the next FRU in the
SRC table.
This ends the procedure.
2. Go to the Product Activity Log. Find the most recent 2765/2766 3120 SRC. Has
a 2765/2766 3140 SRC occurred after the most recent 2765/2766 3120 SRC?
Yes No
↓
Go to step 5 of this procedure.
3. The 2765/2766 3140 SRC indicates that the port is now active. Has a 2105 3002
SRC occurred around the time the problem was first reported?
Yes No
↓
No further service actions are required.
This ends the procedure.
4. A 2105 3002 has occurred, and the link has gone from not active (2765/2766
3120 SRC) to active (2765/2766 3140). If the disk units that reported the 2105
3002 SRC are usable then no further service actions are required and
this ends
the procedure. .
If the disk units that reported the 2105 3002 SRC are not usable then go back to
the 2105 3002 FRU list and work with a FRU other than FCPORT.
5.
Clean the Fibre Channel IOA wrap plug using the cleaning kit – P/N 46G6844
and following the Fiber Optic Cleaning Procedures – SY27-2604-04. If the wrap
plug has been lost, order and clean P/N 05N6768.
Install the wrap plug on the Fibre Channel IOA. After the wrap plug has been
installed, wait 20 seconds and then check for a new 2765/2766 3140 SRC in the
Product Activity Log. The 2765/2766 3140 SRC indicates that the port is active.
Did a new 2765/2766 3140 SRC occur?
Yes No
↓
Replace the Fibre Channel IOA. See “FCIOA” on page 537 for further
instructions.
This ends this procedure.
6. Ask the customer whether the Fibre Channel IOA will attach devices now or
whether the Fibre Channel IOA is to be used at a later time. Is the Fibre
Channel IOA intended to attach devices at this time?
Yes No
↓
The wrap plug must be left installed on the Fibre Channel IOA when it
is not in use. No further service actions are required.
Symbolic FRUs
538
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1