Husqvarna F2303Q0, Руководство по ремонту

Страница: 247 / 322

401550-10
CLUTCH 18
-
Now press the fluid into the system until it emerges from the
hole
(D
of the master cylinder without bubbles.
-
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
- Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
-
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
-
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
The antihopping system reduces the actuation force and
improves clutch controllability.
Ride stability is enhanced as the engine braking effect causes
less slip on the rear wheel thanks to the antihopping system.
The antihopping system uses a two-part inner clutch hub. The
individual parts are connected via helical gears.
The clutch spring preload can be adjusted if necessary.
Low preload, with­
out washer
6)
Moderate preload,
with washer G)
(condition at deliv­
ery)
Washer (59032000101)
High preload, with
washer
0,
Washer (59032000102)
0 mm (0 in)
1.0 mm (0.039 in)
1.5 mm (0.059 in)
...
During acceleration, the engine torque pushes the two parts of
the inner clutch hub against one another via the helical gears.
This force acts in addition to the clutch springs on the clutch lin­
ings.
This additional contact force allows for a lower preload on the
clutch springs. The actuation force on the clutch lever is thus
lower.
245