Honda NSA700A DN-1 2009, Руководство по обслуживанию

Страница: 521 / 654

HYDRAULIC BRAKE
Do not release the
pedal until the
bleed valve has
been closed.
Connect a com m ercially available brake bleeder to
the rear brake caliper bleed valve.
Loosen the bleed valve and operate an air bleed
tool.
If an automatic refill system is not used, add brake
fluid when the flu id level in the reservoir is low.
Close the bleed valve to the specified torque.
TORQUE: 5.4 N m (0.6 kgf-m, 4.0 lbf-ft)
If a brake bleeder is not available, use the follow ing
procedure:
Connect a bleed hose to the front caliper lower
bleed valve.
1. Squeeze the brake pedal, open the bleed valve 1/4
turn and then close it.
2. Release the brake pedal slowly and w ait several
seconds after it reaches the end of its travel.
3. Repeat steps 1 and 2 until a sufficient am ount of
the fluid flow s out of the caliper lower bleed
valve.
NOTE:
It is not a problem if the fluid flow ing out from the
low er bleed valve contains air bubbles because the
lines w ill be bled in later steps.
Connect a bleed hose to the rear caliper bleed
valve.
Repeat step 1 - 3 for the rear caliper bleed valve.
After filling the brake fluid to the pedal brake line,
bleed the air (page 17-11).
PEDAL BRAKE LINE AIR BLEEDING
Tighten the front brake caliper lower and rear brake
caliper bleed valves securely and fill the reservoir to
the "UPPER" level w ith DOT 4 brake fluid from a
sealed container.
17-11