Honda NSA700A DN-1 2009, Руководство по обслуживанию

Страница: 372 / 654

HFT
12.Remove the SCS connector from the DLC.
Install the dum m y connector.
13.lnstall the pillion seat (page 3-4).
HFT INITIALIZATION FAILURE
SYMPTOM
• If the HFT initialization fails, check the follow ing
table to find the cause of the problem.
SHIFT INDICATOR PROBLEM
PROCEDURE
Not blinking to "1" •
4
minutes have not
passed after turning the
ignition switch OFF.
• Faulty operating proce­
dure
• Poor connect the shift
switch connector
• Wait for more than
4
minutes
after turning the ignition
switch OFF.
• Check the operating proce­
dure
• Reconnect the connector
• Inspect the w ire harness
Not blinking to "2" • Engine not started
• Open circuit TACHO sig­
nal line (Engine speed
signal line)
• Start the engine
• Check the PGM-FI DTC and
refer to the DTC index (page
6-14)
• Inspect the w ire harness
N ot blinking to "3"
• Faulty Swash plate mov­
able range (Swash plate
stuck or worn)
• Open circuit TACHO sig­
nal line (Engine speed
signal line)
• S tart the engine
• Check the PGM-FI DTC and
refer to the DTC index (page
6-14)
• Inspect the w ire harness
Not blinking to
"4" • Faulty Swash plate mov­
able range (Swash plate
stuck or worn)
• Open circuit TACHO sig­
nal line (Engine speed
signal line)
• S tart the engine
• Check the PGM-FI DTC and
refer to the DTC index (page
6-14)
• Inspect the w ire harness
Not blinking to "5"
• Open circuit TACHO sig­
nal line (Engine speed
signal line)
• Inspect the w ire harness
No indication
• Battery voltage is low • Use the charged battery
Blinking to
• Detect the HFT problem
code
• Refer to the problem code
index (page 11-26)
DUMMY CONNECTOR
SCS CONNECTOR
11-96