Honda NSA700A DN-1 2009, Руководство по обслуживанию

Страница: 463 / 654

FINAL DRIVE
Be careful n o t to
dam age the side
gear case.
R efer to torque
w rench reading
inform ation (page
14-4).
Refer to torque
w rench reading
inform ation (page
14-4).
Coat a new O-ring w ith engine oil and install it into
the bearing holder groove.
Install the dowel pin and shim.
NOTE:
When the bearing, shaft, holder and/or case have
been replaced, use the 0.50 mm (0.020 in) shim fo r
initial reference.
Install the bearing holder to the side gear ease.
Tem porarily install the bots.
NOTE:
When removing the side gear case bolts (60 mm),
note the location of the bolts.
Hold the gear case in a vise w ith soft jaws.
A pply engine oil to the threads and seating surface
o f a new outer lock nut and tighten it to the speci­
fied torque using a specia tool.
TOOL:
Lock nut wrench, 36 x 47.8 mm 07916-MB00002
TORQUE:
Actual: 98 N-m (10.0 kgf-m, 72 Ibf-ft)
lndicated:89 N-m (9.1 kgf-m, 66 Ibf-ft)
A pply engine oil to the threads and seating surface
o f a new inner lock nut and tighten it to the specified
torque using the special tools.
TOOLS:
Lock nut wrench, 36 x 47.8 mm
Shaft holder
Holder handle
TORQUE:
Actual: 73 N-m (7.4 kgf-m, 54 Ibf-ft)
Indicated:66 N-m (6.7 kgf-m, 49 Ibf-ft)
07916-MB00002
07PAB-0010100
(Not available in
U.S.A.)
07PAB-0010400
SHIM
DOWEL PIN O-RING
60 mm
BOLTS
OUTER LOCK NUT
LOCK NUT WRENCH
INNER
LOCK NUT
SHAFT HOLDER
14-40