Honda NSA700A DN-1 2009, Руководство по обслуживанию

Страница: 137 / 654

FUEL SYSTEM (PGM-FI)
MIL Blink Pattern
• If the HDS pocket tester is not available, DTC can
be read fro m the ECM m em ory by the M IL blink
pattern.
• The n u m b e r o f MIL blinks is the equivale nt the
m ain code o f the DTC (the sub code cannot be
displayed by the MIL).
• The MIL has tw o types of blinks, a long blink and
short blink. The long blinking lasts fo r 1.3 sec­
onds, the short blinking lasts fo r 0.5 seconds.
One long b link is the equivale nt o f ten short
blinks. For exam ple, when tw o long blinks are
fo llo w e d by five sh o rt blinks, the MIL is 25 (tw o
long blinks = 20 blinks, plus five sh o rt blinks).
• W hen the ECM stores m ore than one DTC, the
MIL w ill indicate them by b linking in the o rder
fro m the low est num ber to highest num ber.
MIL Check
W hen the ig n itio n sw itch is tu rn e d ON and engine stop switch " Q ", the MIL w ill stay on fo r a fe w sec­
onds, then go off. If the MIL does n ot com e on, tro u b le sh o o t the MIL c ircu it (page 6-36).
CURRENT DTC/FREEZE DTC
The DTC is indicated in tw o ways according to the fa ilu re status.
• In case the ECM detects the problem at present, the M IL w ill com e on and the M IL w ill start to blink
as its DTC w hen the side stand is low ered. It is possible to readout the MIL b link pattern as the cur­
rent DTC.
• In case the ECM does not detect any problem at present but has a problem stored in its m em ory, the
MIL w ill not lig h t and blink. If it is necessary to retrieve the past problem , readout the freeze DTC by
fo llo w in g the DTC readout procedure.
HDS POCKET TESTER INFORMATION
• The HDS can readout the DTC, freeze data, cu rre n t data and other ECM condition .
How to connect the HDS Pocket Tester
Turn the ig n itio n sw itch to OFF.
Remove the m ain seat (page 3-4).
Remove the d u m m y connector fro m the DLC.
Connect the HDS pocket tester to the DLC.
Turn the ig n itio n sw itch to ON and engine stop
sw itch " Q ”, check the DTC and freeze data.
N O T E .
• Freeze data indicates the engine c o n d itio n s w hen
the firs t m a lfu n ctio n was detected.
ECM reset
The HDS can reset the ECM data including the DTC,
freeze data and som e learning m em ory.
DTC READOUT
Start the engine and check the MIL.
• If the engine w ill not start, tu rn the starter m o to r
fo r m ore than 10 seconds and check th a t the MIL
blinks.
• W hen the ig n itio n switch is tu rned ON, the MIL
w ill stay on fo r a fe w seconds, then go off.
If the MIL stays on or blinks, connect the HDS Pocket
Tester to the DLC (page 6-12).
Read the DTC, freeze data and fo llo w the tro u b le ­
shooting index (page 6-14).
To read the DTC w ith the MIL b linking, refer to the
fo llo w in g procedure.
CONNECTOR COVER
6-12