Honda NSA700A DN-1 2009, Руководство по обслуживанию

Страница: 416 / 654

CRANKCASE/CRANKSHAFT
Do n o t rotate the
cran ksha ft during
inspection.
A pply engine oil to the threads and seating surfaces
of the bearing cap nuts.
Carefully install the connecting rods and bearing
caps on the correct crankpins.
Install the bering cap nuts and tighten them in sev­
eral steps alternately.
TORQUE: 42 N m (4.3 kgf-m, 31 Ib fft)
BEARING SELECTION
Record the connecting rod I.D. code number.
NOTE:
Number 1 or 2 on the connecting rod is the code for
the connecting rod I.D.
Remove the bearing caps and measure the com ­
pressed plastigauge at its widest point on each
crankpin to determine the oil clearance.
SERVICE LIMIT: 0.07 mm (0.003 in)
If the clearance exceeds the service lim it, select the
correct replacement bearings as follows.
PLASTIGAUGE
Record the crankpin O.D. code letter.
NOTE:
Letters A or B on each crank w eight is the code for
the crankpin O.D.
Cross reference the connecting rod and crankpin
codes to determine the replacement bearing color
code.
CONNECTING ROD I.D. CODE NUMBER
CRANKPIN O.D. CODE LETTERS
13-10