Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-36
z
If the management device receives NDP information form a member device within
the holdtime, the member device stays in the normal state and does not need to be
added to the cluster again.
z
Note that, you need only execute the command on a management device, which
will advertise the holdtime value to all member devices in the cluster.
Examples
# Set the neighbor information holdtime of the cluster members to 30 seconds.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] holdtime 30
2.3.17 ip-pool
Syntax
ip-pool
administrator-ip-address
{
ip-mask | ip-mask-length
}
undo ip-pool
View
Cluster view
Parameters
administrator-ip-address
: IP address for the device to be set as the management
device of a cluster.
ip-mask
: Mask of the cluster IP address pool.
ip-mask-length
: Mask length of the cluster IP address pool.
Description
Use the
ip-pool
command to configure a private IP address pool on the management
device.
Use the
undo ip-pool
command to cancel the IP address pool configuration.
Before creating a cluster, you must first configure a private IP address pool. When a
candidate device joins a cluster, the management device dynamically assigns a private
IP address in the pool to it, so that the candidate device can communicate with other
devices in the cluster. This enables the management device to manage and maintain
member devices in the cluster.
As the IP address pool of a cluster cannot be modified, be sure to execute these two
commands before a cluster is created.
