Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
Chapter 1 Port Basic Configuration
Commands
1-3
Parameter
interface
-
type
: Port type.
interface-number
: Port number.
source-agg-id
: Source aggregation group number, in the range of 1 to 28. The port with
the smallest port number in the aggregation group is used as the source port.
destination
-
agg
-
id
: Destination aggregation group number, in the range of 1 to 28.
interface-list
: Destination port list,
interface-list = interface-type interface-number
[
to
interface-type interface-number
] &<1-10. &<1-10> means that you can input up to 10
ports/port ranges.
Description
Use the
copy configuration
command to duplicate the configuration of a port to
specified ports to keep consistent configuration on them.
Note:
z
If you specify a source aggregation group ID, the system uses the port with the
smallest port number in the aggregation group as the source.
z
If you specify a destination aggregation group ID, the configuration of the source
port will be copied to all ports in the aggregation group and all ports in the group will
have the same configuration as that of the source port.
The configuration that can be copied includes: VLAN configuration, protocol-based
VLAN configuration, LACP configuration, QoS configuration, GARP configuration, STP
configuration and initial port configuration.
z
VLAN configuration: includes IDs of the VLANs allowed on the port and the default
VLAN ID of the port;
z
Protocol-based VLAN configuration: includes IDs and indexes of the
protocol-based VLANs allowed on the port;
z
Link aggregation control protocol (LACP) configuration: includes LACP
enable/disable status;
Note:
The
copy
command can only be used to copy the configuration of LACP’s enable state,
but not to copy the configuration of aggregation group, i.e., you can not add a port to the
aggregation group bye the command.
