Command Manual (For Soliton) – GVRP
H3C S3100 Series Ethernet Switches
Chapter 1 GVRP Configuration Commands
1-4
z
The timeout ranges of the timers vary depending on the timeout values you set for
other timers. If you want to set the timeout time of a timer to a value out of the
current range, you can set the timeout time of the associated timer to another
value to change the timeout range of this timer.
The following table describes the relations between the timers:
Table 1-2
Relations between the timers
Timer
Lower threshold
Upper threshold
Hold 10
centiseconds
This upper threshold is
less than or equal to
one-half of the timeout
time of the Join timer. You
can change the threshold
by changing the timeout
time of the Join timer.
Join
This lower threshold is
greater than or equal to
twice the timeout time of
the Hold timer. You can
change the threshold by
changing the timeout time
of the Hold timer.
This upper threshold is
less than one-half of the
timeout time of the Leave
timer. You can change the
threshold by changing the
timeout time of the Leave
timer.
Leave
This lower threshold is
greater than twice the
timeout time of the Join
timer. You can change the
threshold by changing the
timeout time of the Join
timer.
This upper threshold is
less than the timeout time
of the LeaveAll timer. You
can change the threshold
by changing the timeout
time of the LeaveAll timer.
LeaveAll
This lower threshold is
greater than the timeout
time of the Leave timer.
You can change threshold
by changing the timeout
time of the Leave timer.
32,765 centiseconds
Note:
In networking, the following GARP timer settings are recommended:
z
GARP hold timer: 100 centiseconds (1 second)
z
GARP Join timer: 600 centiseconds (6 seconds)
z
GARP Leave timer: 3000 centiseconds (30 seconds)
Related commands:
display
garp timer
.
