Command Manual (For Soliton) – CLI
H3C S3100 Series Ethernet Switches
Chapter 1 CLI Configuration Commands
1-4
1.1.3 super
Syntax
super
[
level
]
View
User view
Parameters
level
: User level, in the range of 0 to 3.
Description
Use the
super
command to switch from the current user level to a specified level.
Executing this command without the
level
argument will switch the current user level to
level 3 by default.
Note that:
z
Users logged into the switch fall into four user levels, which correspond to the four
command levels respectively. Users at a specific level can only use the
commands at the same level or lower levels.
z
You can switch between user levels after logging into a switch successfully. The
high-to-low user level switching is unlimited. However, the low-to-high user level
switching requires the corresponding authentication. The authentication mode can
be set through the
super authentication-mode
command.
z
For security purpose, the password entered is not displayed when you switch to
another user level. You will remain at the original user level if you have tried three
times but failed to enter the correct authentication information.
Related commands:
super authentication-mode
,
super password
.
Examples
# Switch from the current user level to user level 3, using super password
authentication.
<Sysname> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
# Switch from the current user level to level 3, using HWTACACS authentication.
<Sysname> super 3
Username: user@system
Password:
