Gestetner G060, Руководство по обслуживанию

Страница: 855 / 1106

G082
PRINTER CONTROLLER SERVICE MODE
SM 5-3 G082
5.2 PRINTER CONTROLLER SERVICE MODE
5.2.1 SERVICE MODE MENU (“1. SERVICE")
Mode No.
(Class 1 and 2)
Function / [ Setting ]
[Clear Setting]
1 Clear Setting Initializes settings in the “System” menu of the user
mode. This is the same as “Restore Default” in user
mode.
[Bit Switch]
2 Bit Switch 2 *
When bit 4 of bit switch 2 is set to 1, the Letterhead
Mode is enabled.
NOTE: Currently the other bit switches are not used.
These switches have to be set to “0".
[Password Clear]
1 Password Clear Clears the password that was specified by the user
program mode – this password prevents access to
some user tools.
NOTE: Use this function to clear the password when
the user forgets it.
[Key Repeat]
1 Key Repeat * When enabled (On), this function allows the display
to continually advance (scroll) when a key is held
down, and makes the LEDs blink more slowly. This
was introduced to help users who may be physically
challenged operate the machine more freely.
NOTE: An asterisk (*) to the right hand side of the mode number column
means that this mode is stored in the NVRAM. If you do a RAM clear,
this SP mode will be reset to the default value.
5.2.2 BIT SWITCH PROGRAMMING
NOTE: Currently, the bit switches are not being used.
1. Enter the SP mode, select “Service Menu”, then
press ► , then press
W
.
2. Press ► .
3. Adjust the bit switch using the following keys.
•
V
/
W
: Move to the next bit.
•
◄ : Exit without saving changes.
•
►
: Exit and save changes.
NOTE: The left digit on the display is bit 7 and the right digit is bit 0.
4. Press ► to save changes and exit.
<Service>
Bit Switch >>
Bit Switch
Bit switch 2
Sw#2 00000000
bit0 _
⇒
Rev. 10/2003