Gestetner G060, Руководство по обслуживанию

Страница: 551 / 1106

Copie
r
F
eat
u
re
E
x
pa
nde
r
G
570
COPY SP MODE
SM 5-13 G570
1
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
2 Tray 2 B4/LG Specifies the paper size for tray 2.
[ 0 or 1 / 0 / - ] Alphanumeric
0: B4 lengthwise, 1: LG lengthwise
This specifies which size is detected for a sensor
output of 1101 (see section 6 for details).
US: 1 FA
3 Tray 2 A4/LT Specifies the paper size for tray 2.
[ 0 or 1 / 0 / - ] Alphanumeric
0: A4 lengthwise, 1: LT lengthwise
This specifies which size is detected for a sensor
output of 0110 (see section 6 for details).
US: 1 FA
902
4 Tray 2 B5/LT
*
BCU
Specifies the paper size for tray 2.
[ 0 or 1 / 0 / - ] Alphanumeric
0: LT, 1: B5 lengthwise
This specifies which size is detected for a sensor
output of 1011 (see section 6 for details).
[Fusing Idling Time]
910
1 Fusing Idling Time *
BCU
Specifies the timer for deciding whether to do
fusing idling when receiving a print command.
When receiving a new job within the time specified
in this SP mode after the last job is completed,
fusing idling is not done because the fusing
section was already warmed up during the last
job.
[ 0 to 180 / 1 / 1 minute/step ] DFU
[Machine Temp. Cor.] Machine Temperature Correction
Th: Threshold, Heating or Pressure roller
Corrects the fusing temperature depending on the temperature inside the machine.
If the temperature inside the machine is too high or low, this may cause hot or cold offset
image at the fusing section. To avoid the offset image, the fusing temperature is corrected
depending on the temperature inside machine, which is monitored by the thermistor
located on the right side of the laser optics housing unit.
If the temperature inside the machine is detected as high or low (based on the settings of
SP1-912-001 or 002), the fusing temperature is decreased or increased by the
temperature specified in SP1-912-003 to 006.
1
Th:High Temp Sets the threshold for entering the high
temperature condition.
[ 0 to 50 / 30 / 1
°
C/step]
2 Th:Low Temp Sets the threshold for entering the low
temperature condition.
[ 0 to 50 / 17 / 1
°
C/step]
3 H:High Temp Sets the fusing temperature decrease for the high
temperature condition.
[ 0 to 15 / 0 / 1
°
C/step]
4 P:High Temp
[ 0 to 15 / 0 / 1
°
C/step]
5 H:Low Temp Sets the fusing temperature increase for the low
temperature condition.
[ 0 to 15 / 5 / 1
°
C/step]
912
6 P:Low Temp
*
BCU
[ 0 to 15 / 5 / 1
°
C/step]