Gestetner G060, Руководство по обслуживанию

Страница: 1027 / 1106

SC TABLE
G060 4-30 SM
SC No. Item Definition Possible Cause
Related
SCs
Troubleshooting Procedure Type
SC822 Self-diagnostic error: HDD (Hard Disk Drive) [XXXX]: Detailed error code
[3003] Timeout error
[3004] Command
error
When the main switch is
turned on or starting the self-
diagnostic, the HDD stays
busy for the specified time or
more.
•
Loose connection
•
Defective HDD
•
Defective controller
1. Turn the main switch off and on.
2. Check that the HDD is properly
connected to the controller.
3. Replace the HDD.
4. Replace the controller.
CTL
SC 823 Self-diagnostic error: NIB [XXXX]: Detailed error code
[6101] MAC address
check sum
error
The result of the MAC address
check sum does not match the
check sum stored in ROM.
[6104] PHY IC error The PHY IC on the controller
cannot be properly recognized.
[6105] PHY IC loop-
back error An error occurred during the
loop-back test for the PHY IC
on the controller.
•
Defective controller
1. Turn the main switch off and on.
2. Replace the controller. CTL
SC 824
[1401] Self-diagnosis
error:
Standard
NVRAM The controller cannot
recognize the standard
NVRAM installed or detects
that the NVRAM is defective. •
Loose connection
•
Defective standard
NVRAM
•
Defective controller
1. Turn the main switch off and on.
2. Check the standard NVRAM is firmly
inserted into the socket.
3. Replace the NVRAM.
Replace the controller.
CTL
SC 827 Self-diagnostic error: Standard SRAM DIMM [XXXX]: Detailed error code
[0201] Verification
error
Error detected during a
write/verify check for the
standard RAM (SRAM DIMM).
•
Loose connection
•
Defective SRAM
DIMM
•
Defective controller
1. Turn the main switch off and on.
2. Replace the SRAM DIMM.
3. Replace the controller. CTL
Rev. 09/2003