Gestetner G060, Руководство по обслуживанию

Страница: 521 / 1106

SC TABLE
SM 4-39 G570
[0801]
to
[4005] CPU error Same as [0001] B
SC 821
[0D05] Self-diagnosis
error: ASIC The CPU checks if the ASIC
timer works properly
compared with the CPU
timer. If the ASIC timer does
not function in the specified
range, this SC code is
displayed.
•
System firmware
problem
•
Defective RAM-DIMM
•
Defective controller
1. Turn the main switch off and on.
2. Reinstall the controller system
firmware.
3. Replace the RAM-DIMM.
4. Replace the controller board.
B
SC822 Self-diagnostic error: HDD (Hard Disk Drive) [XXXX]: Detailed error code
[3003] Timeout error
[3004] Command error
When the main switch is
turned on or starting the
self-diagnostic, the HDD
stays busy for the specified
time or more. •
Loose connection
•
Defective HDD
•
Defective controller
1. Turn the main switch off and on.
2. Check that the HDD is properly
connected to the controller.
3. Replace the HDD.
4. Replace the controller.
B
SC 823 Self-diagnostic error: NIB [XXXX]: Detailed error code
[6101] MAC address
check sum error
The result of the MAC
address check sum does not
match the check sum stored
in ROM.
[6104] PHY IC error The PHY IC on the
controller cannot be properly
recognized.
[6105] PHY IC loop-
back error An error occurred during the
loop-back test for the PHY
IC on the controller.
•
Defective controller 1. Turn the main switch off and on.
2. Replace the controller. B
SC 824
[1401] Self-diagnosis
error: Standard
NVRAM The controller cannot
recognize the standard
NVRAM installed or detects
that the NVRAM is
defective.
•
Loose connection
•
Defective standard
NVRAM
•
Defective controller
1. Turn the main switch off and on.
2. Check the standard NVRAM is firmly
inserted into the socket.
3. Replace the NVRAM.
4. Replace the controller.
B
Rev. 09/2003