Gestetner G060, Руководство по обслуживанию

Страница: 589 / 1106

Copie
r
F
eat
u
re
E
x
pa
nde
r
G
570
COPY SP MODE
SM 5-51 G570
SP6-XXX (Peripherals)
6
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[DF Registration Adj.] DF Registration Adjustment
1
Side-to-Side
2 Leading Edge
Adjusts the side-to-side and leading registration of
originals with the ARDF.
[ -30 to 30 / 0 / 0.1 mm/step ]
3 Buckle: Duplex Front
4 Buckle: Duplex Rear
Adjusts the amount of paper buckle to correct
original skew for the front and rear sides.
[ -4.2 to 4.2 / 0 / 0.1 mm/step ]
006
5 Rear Edge Erase
*
NV
Adjusts the erase margin at the original trailing
edge.
[ -20 to 10 / 0 / 0.5 mm/step ]
[ADF Input Check]
1
Group 1
007
2 Group 2
Displays the signals received from the sensors
and switches of the ARDF. (See 5.4.2)
[ADF Output Check]
1
Fee-in Motor Fwd.
2 Feed-in Motor Rev.
3 Drive Motor Fwd.
4 Reverse Motor Fwd.
5 Reverse Motor Rev.
6 Feed Clutch
7 Inverter Solenoid
8 Pick-up Motor Fwd.
008
9 Pick-up Motor Rev.
Activates the electrical components for functional
check.
It is not possible to activate more than one
component at the same time.
[DF Free Run]
1
Duplex Mode
009
2 Stamp Mode
Performs a DF free run in duplex mode or stamp
mode.
[Stamp Position Adj.] Fax Stamp Position Adjustment 010
1 Stamp Position Adj. *
NV
Adjusts the horizontal position of the stamp on the
scanned originals.
[ -3.5 to 3.5 / 0 / 0.5 mm/step ]
[Original Size Priority] Original Size Detection Priority
016
1 Original Size Priority *
NV
Specifies the original size for a size detected by
the original sensor, since original sensors cannot
recognize all sizes.
[ 0 or 1 / 0 / - ]
0: Setting 1
1: Setting 2
Setting 1 Setting 2
Bit 7 A4 (L) LT (L)
Bit 6 11”x15” DLT (L)
Bit 5 DLT (L) 11”x15”
Bit 4 LT (S) US Exec (S)
Bit 3 LT (L) 8”x10” (L)
Bit 2 LG (L) F4 (L)
Bit 1 A4 (L) 16K (L)
Bit 0 8K (L) DLT (L)
Bits used for detection differ depending on
destination as shown below.
Bit 7 to 6: Only for Japan
Bit 5 to 2: Only for US
Bit 1 to 0: Only for EU/AA