Gestetner G060, Руководство по обслуживанию

Страница: 199 / 1106

PRINTER ENGINE SERVICE MODE
SM 5-31 G060
Serv
ic
e
Ta
b
le
s
5
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[Memory Clear 1]
1 All P Resets all the controller and engine settings to
their defaults and the counters to 0.
To clear the memory, enter this SP mode, press
the Enter key, then turn the main switch off and
on.
NOTE: All settings are reset to the defaults. SMC
sheets should be printed out before doing
a memory clear.
See NOTE 1 at the end of the SP table for a list of
settings cleared.
2 ENG All Clears all the engine settings and counters.
Engine settings and engine counters can be
cleared independently with SP5-998-001 and 002.
3 SCS P Clears the system settings.
4 IMH P
5 MCS P
Not used.
8 PRT P Clears the user mode system settings.
801
11 NCS P Clears the network settings.
EngineFreeRun
802
1 EngineFreeRun P Performs a free run on the printer engine.
NOTE:
•
The machine starts free run in the same
condition as the sequence of A4/LT printing
from the 1st tray. Therefore, paper should be
loaded in the 1st tray, but paper is not fed.
•
The main switch has to be turned off and on
after using the free run mode for a test.
803 [Input Check] See section 5-3-2.
804 [Output Check] See section 5-3-3.
[Destination] Destination Code Display 808
1 Destination * Displays the destination code.
[SC ON/OFF] SC Detection ON/OFF
809
1 SC ON/OFF * Enable or disables the service call detection (SC
codes will be ignored if disabling this SP mode).
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
[SC Reset] 810
1 SC Reset * Resets a type A service call condition.
NOTE: Turn the main switch off and on after
resetting the SC code.
[SN Display] Serial Number Display 811
2 SN Display * Displays the machine serial number.
[FAX TEL No.]
812
2 FAX TEL No. *
P
Sets the fax or telephone number for a service
representative. This number is printed on the
Counter List, which can be printed with the user’s
“Counter” menu if the Meter Charge mode is
selected with SP5-930-1.
This can be up to 13 characters (both numbers
and alphabetic characters can be input).
[HDD Init.] HDD Initialization
832
1 HDD Init. P Initializes the hard disk. Use this SP mode only in
there is a hard disk error.