Gestetner G060, Руководство по обслуживанию

Страница: 184 / 1106

PRINTER ENGINE SERVICE MODE
G060 5-16 SM
2
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
9 Upper Limit *
#
Specifies the maximum possible toner supply,
expressed as a percentage of the maximum
amount of toner that can possibly be supplied for
a sheet of paper.
If too much toner is supplied to the development
unit especially for black or in the low humidity
condition, this may cause dirty background due to
insufficient agitation. This SP mode limits the
maximum possible toner supply for black and only
in the low humidity condition for color.
[ 20 to 70 / 42 / 1 %/step ] DFU
NOTE:
The main switch must be turned off and on
to effect the setting change.
10 LowCoverage[K] Adjusts the toner supply amount (fixed rate) when
making multiple prints of pages with low image
ratio (coverage).
When printing with a low image ratio, toner
concentration is controlled only with Vt outputs
since pixel count is not done for low image ratios.
This may cause the attraction force between toner
and carrier to increase, resulting in low image
density on outputs. To prevent this, the machine
counts the number of pixels and supplies a fixed
amount of toner if the accumulated number of
pixels becomes greater than the specified level.
[ 0 to 100 / 9 / 1 %/step ] DFU
11 LowCoverage[Y] [ 0 to 100 / 9 / 1 %/step ] DFU
12 LowCoverage[M] [ 0 to 100 / 5 / 1 %/step ] DFU
208
13 LowCoverage[C] [ 0 to 100 / 9 / 1 %/step ] DFU
[Toner Counter] Toner Supply Counter ([Color])
5 [K] *
6 [Y] *
7 [M] *
210
8 [C] *
Displays the total time that the toner supply clutch
has been on.
This data is stored in the memory chip on each
toner cartridge.
[ 0 to 5000 / - / 1 second/step ]
[Toner Near/End] Toner Near End / End Detection Threshold ([Color])
1 Start [K] * When the amount of toner amount left in the
cartridge becomes less than this value, the
machine starts monitoring the Vt values for toner
near end detection.
[ 0 to 1000 / 600 / 10 g/step ]
2 Start [YMC] * [ 0 to 1000 / 300 / 10 g/step ]
5 Near [K] *
6 Near [YMC] *
Specifies the threshold for toner near-end
detection.
The machine detects toner near-end when the
following happens 10 times consecutively.
Vt > Vref + Threshold
[ 0 to 5.0 / 0.4 / 0.1 V/step ]
7 End [K] *
212
8 End [YMC] *
Specifies the threshold for toner end detection.
The machine detects toner end when the following
happens 10 times consecutively. Then, the
machine stops printing, even during a print job.
Vt > Vref + Threshold
[ 0 to 5.0 / 0.8 / 0.1 V/step ]