Gestetner G060, Руководство по обслуживанию

Страница: 739 / 1106

F
ax Un
it
G
307
BIT SWITCHES
SM 3-15 G307
System Switch 0A SP No. 1-101-011
No FUNCTION COMMENTS
0-2
Not used Do not change the settings.
3 Continuous polling reception
0: Disabled 1: Enabled This feature allows a series of stations to be polled
in a continuous cycle. This will continue until the
polling reception file is erased.
The dialing interval is the same as memory
transmission.
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled 0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting
when the external telephone is not by the
machine, or if a wireless telephone is connected
as an external telephone.
1: The user can dial on the machine’s ten-key pad
when the handset is off-hook.
5 On hook dial
0: Disabled 1: Enabled 0: On hook dial is disabled.
6
Line used for G3 transmission
0: PSTN 1: ISDN If an ISDN unit has been installed, this bit
determines whether G3 transmissions go out over
the PSTN or the ISDN.
7 Line used when the machine
falls back to G3 from G4 if the
other end is not a G4 machine
0: PSTN 1: ISDN This bit switch has no effect if Communication
Switch 07 bit 0 is set to 0.
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E SP No. 1-101-015
No FUNCTION COMMENTS
0-2
Not used Do not change the settings.
3 Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same) 0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
Note that manual tx and rx are not possible with
this setting.
4-7
Not used Do not change the settings.