Gestetner G060, Руководство по обслуживанию

Страница: 1024 / 1106

SC TABLE
SM 4-27 G060
SC No. Item Definition Possible Cause
Related
SCs
Troubleshooting Procedure Type
SC 729 Finisher punch
motor error The punch home position is
not detected within 250 ms
after the punch clutch turns on. •
Loose connection
•
Defective punch H.P.
sensor
•
Defective punch
clutch
•
Defective punch hole
motor
1. Turn the main switch off and on.
2. Check if the connectors of sensor,
clutch and/or motor are properly
connected.
3. Replace the punch H.P. sensor.
4. Replace the punch clutch.
5. Replace the punch hole motor.
SC 730 Finisher
stapler motor
error The stapler home position is
not detected within a specified
time after the staple motor
turns on.
•
Loose connection
•
Defective stapler H.P.
sensor
•
Defective stapler
motor
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the stapler H.P. sensor.
4. Replace the stapler motor.
SC 731 Finisher exit
guide plate
motor error The exit guide plate open
sensor is not activated within a
specified time after the exit
guide plate motor turns on. •
Loose connection
•
Defective exit guide
plate open sensor
•
Defective exit guide
plate motor
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the exit guide plate open
sensor.
4. Replace the exit guide plate motor.
SC 732 Finisher tray 1
shift motor
error Tray 1 home position is not
detected within a specified
time after the tray 1 shift motor
turns on. •
Loose connection
•
Defective tray shift 1
sensor
•
Defective tray 1 shift
motor
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the tray shift 1 sensor.
4. Replace the tray 1 shift motor.
SC 733 Finisher tray 2
lift motor error •
The lower stack height 1
sensor is activated
consecutively (detecting
paper) for 15 seconds after
the shift tray starts moving
up.
•
The lower stack height
sensor 1 is deactivated
consecutively (not detecting
paper) for 15 seconds after
the shift tray starts moving
down.
•
Loose connection
•
Defective lower stack
height 1 sensor
•
Defective tray 2 lift
motor
•
Motor overload
1. Turn the main switch off and on.
2. Check if the connectors of the sensor
and motor are properly connected.
3. Replace the lower stack height 1
sensor.
4. Replace the tray 2 lift motor.
Rev. 09/2003