Gestetner G060, Руководство по обслуживанию

Страница: 203 / 1106

PRINTER ENGINE SERVICE MODE
SM 5-35 G060
Serv
ic
e
Ta
b
le
s
5
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
5 Stand-by * Enables or disables the line position adjustment
during stand-by mode when the temperature
differs by the amount specified in SP5-993-003
from the temperature at the last adjustment.
[ 0 or 1 / 0 / - ] Alphanumeric
0: Disabled
1: Enabled
6 Job Start Enables or disables the line position adjustment
just before starting a color print job when the
temperature differs by the amount specified in
SP5-993-003 from the temperature when the
machine woke up from energy saver mode.
[ 0 or 1 / 1 / - ]
0: Disabled
1: Enabled
7 Result * Displays the result of the latest line position
adjustment in 4 digits.
First 2 digits: Error detected on the front ID sensor
Last 2 digits: Error detected on the rear ID sensor
Refer to the Troubleshooting section for more
details about the two-digit codes.
8 Exe. Counter * Displays how many times the line position
adjustment has been executed.
Counts up by +1 normally.
After a forced adjustment and a PCU
replacement, it counts up +3
Also includes adjustments done at the factory.
9 Error Counter * Displays how many times errors have been
detected during the line position adjustment.
The way that the auto line position adjustment is done can be adjusted using the following
SP modes (SP5-993-010 to 021). These are coefficients used for the adjustment.
Normally, do not change except if the automatic adjustment gives poor results immediately
after installing a new optics housing unit. Change the value then do a forced line position
adjustment (SP 5-993-2) to check the effects of the changes.
Example: If magenta is always shifted one dot to the left, reduce 5-993-11 by 1.
10
M Reg. [Y] *
11 M Reg. [M] *
12 M Reg. [C] *
A fine adjustment to the main-scan registration.
[ -128 to 127 / 0 / 1 dot/step ] FA
1 dot = 20
µ
13 M Mag. [Y] *
14 M Mag. [M] *
15 M Mag. [C] *
A fine adjustment to the main-scan magnification.
[ -100 to 100 / 0 / 0.01 %/step ] FA
NOTE: The setting changes in this SP mode will
be affect the next line position adjustment.
16 S Reg. 600[Y] *
17 S Reg. 600[M] *
18 S Reg. 600[C] *
19 S Reg. 1200[Y] *
20 S Reg. 1200[M] *
993
21 S Reg. 1200[C] *
A fine adjustment to the sub-scan registration for
each color (color registration).
[ -128 to 127 / 0 / 1 dot/step ] FA
600dpi: 1 dot = 40
µ
1200 dpi: 1 dot = 20
µ