Gestetner G060, Руководство по обслуживанию

Страница: 544 / 1106

SERVICE MODE
G570 5-6 SM
As shown in the following table, the process speed (mm/s) depends on the print
mode (B&W or Color), resolution, and/or type of paper selected. Some SP mode
settings depend on the process speed.
Mode
Resolution
(dpi)
Line speed
(mm/s)
Print speed
(ppm)
600 x 600
1,200 x 600
185 38
B/W
1,200 x 1,200 125 28
600 x 600
1,200 x 600
125 28
Color
1,200 x 1,200 62.5 14
OHP/Thick
600 x 600
1,200 x 600
1,200 x 1,200
62.5 10
Others
The following symbols are used in the SP mode tables.
FA: Factory setting
(Data may be adjusted from the default setting at the factory. Refer to the factory
setting sheets enclosed, which is located underneath the jammed paper removal
decal.)
DFU: Design / Factory Use only
Do not touch the SP mode in the field.
A sharp (#) to the right hand side of the mode number column means that the main
switch must be turned off and on to effect the setting change.
An asterisk (*) to the right hand side of the mode number column means that this
mode is stored in the EEPROM (Engine) or NVRAM (Printer Controller). If you do a
RAM clear, this SP mode will be reset to the default value. ‘BCU’, ‘CTL’, ‘SBU’, and
‘NV’ indicate which NVRAM contains the data.
•
BCU: NVRAM on the BCU board
•
CTL: NVRAM on the controller board
•
SBU: NVRAM on the SBU board (this NVRAM cannot be removed in the
field)
•
NV: NVRAM on the NVRAM expansion board (user account enhancement
kit)
The settings of each SP mode are explained in the right-hand column of the SP
table in the following manner.
[ Adjustable range / Default setting / Step ] Alphanumeric
NOTE: If “Alphanumeric” is written to the right of the bracket as shown above, the
setting of the SP mode is displayed on the screen using alphanumeric
characters instead of only numbers. However, the settings in the bracket in
the SP mode table are explained by using only the numbers.