Gestetner G060, Руководство по обслуживанию

Страница: 172 / 1106

PRINTER CONTROLLER SERVICE MODE
G060 5-4 SM
As shown in the following table, the process speed (mm/s) depends on the print
mode (B&W or Color), resolution, and/or type of paper selected. Some SP mode
settings depend on the process speed.
Mode
Resolution
(dpi)
Line speed
(mm/s)
Print speed
(ppm)
600 x 600
1,200 x 600
185 38
B/W
1,200 x 1,200 125 28
600 x 600
1,200 x 600
125 28
Color
1,200 x 1,200 62.5 14
OHP/Thick
600 x 600
1,200 x 600
1,200 x 1,200
62.5 10
Others
The following symbols are used in the SP mode tables.
FA: Factory setting
(Data may be adjusted from the default setting at the factory. Refer to the factory
setting sheets enclosed, which is located underneath the jammed paper removal
decal.)
DFU: Design / Factory Use only
Do not touch the SP mode in the field.
CF: Copier Feature (CF) Expander Unit
SP modes with “CF” can be seen on the screen when the CF expander unit is
installed.
“P” in the right hand side of the mode number column means that this SP mode
relates to the Printer Controller. If “P” is not in the column, this SP mode relates to
the Printer Engine.
A sharp (#) to the right hand side of the mode number column means that the main
switch must be turned off and on to effect the setting change.
An asterisk (*) to the right hand side of the mode number column means that this
mode is stored in the EEPROM (Engine) or NVRAM (Printer Controller). If you do a
RAM clear, this SP mode will be reset to the default value.
The settings of each SP mode are explained in the right-hand column of the SP
table in the following manner.
[ Adjustable range / Default setting / Step ] Alphanumeric
NOTE: If “Alphanumeric” is written to the right of the bracket as shown above, the
setting of the SP mode is displayed on the screen using alphanumeric
characters instead of only numbers. However, the settings in the bracket in
the SP mode table are explained by using only the numbers.