Fuji Xerox DocuPrint C5005 d, Руководство пользователя

Страница: 271 / 462

6.7 Error Messages and Error Codes
271
016-406 Though the [EAP-TLS] is selected as the authentication protocol for 802.1x authentication, the
SSL client certificate is not specified or removed.
Take one of the following measures:
1)Store an SSL client certificate in the machine, and set it as the SSL client certificate.
2)If the SSL client certificate cannot be set, select an authentication method other than [EAP-
TLS].
Refer to
• CentreWare Internet Services online help
016-450 The SMB host name already exists.
Change the host name.
016-453 Updating of the IPv6 address and host name for the DNS server failed.
Check whether the IP address of the DNS server is set correctly.
016-454 Unable to retrieve the IP address from DNS.
Confirm the DNS configuration and IP address setting.
016-455 Connection to the SNTP server timed out.
Confirm the network cable connection and the IP address of the SNTP server are correct.
016-456 Received a message from the SNTP server stating that the server is not synchronized with the
standard time source.
Confirm the SNTP server settings.
016-461 When [High] is set for the [Assurance Level] under the [Image Log Transfer] on the control panel,
a new job may not be able to be created due to a restriction on new job creation because of the
congestion of un-transferred image logs.
Check the status of the server that manages the image log and the network status, and eliminate
whatever is obstructing image log transfer to the image log server.
Perform of the two following steps.
• Check that [At power On] or [End of selections] is set to [Enabled] under [Transfer Timing] and
transfer all non-transferred logs. However, if only [At power On] is [Enabled] under [Transfer
Timing], you must turn the power on/off to transfer non-transferred logs.
• On the control panel change the [Assurance Level] setting to [Low].
In this case, image logs may be deleted sequentially without being transferred.
When turning the power OFF/ON or automatically rebooting with PostScript, turn the printer OFF/
ON again.
Refer to
• “ [Image Log Control]” (P. 187)
016-500
016-502 An internal error occurred.
Re-try the same operation. If this does not correct the situation, it could indicate a mechanical
problem. Contact our Customer Support Center or your dealer.
016-503 The SMTP server name could not be resolved when sending e-mail.
Check the [Properties] of CentreWare Internet Services to see if the SMTP server settings are
configured correctly. Also check the DNS server settings.
Refer to
• CentreWare Internet Services online help
016-504 The POP3 server name could not be resolved when sending e-mail.
Check the [Properties] of CentreWare Internet Services to see if the POP server settings are
configured correctly. Also check the DNS server settings.
Refer to
• CentreWare Internet Services online help
016-505 Log in to the POP3 server failed when sending e-mail.
Check the [Properties] of CentreWare Internet Services to see if the user name and password
used by POP3 are correct.
Refer to
• CentreWare Internet Services online help
Error Code Cause/Remedy