Endress+Hauser Proline Promag W 500, Руководство по эксплуатации

Страница: 127 / 262

Proline Promag W 500 PROFINET Commissioning
Hauser 127
Minimum frequency value →  127
Maximum frequency value →  128
Measuring value at minimum
frequency →  128
Measuring value at maximum
frequency
→  128
Failure mode →  128
Failure frequency →  128
Invert output signal
→  128
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output. • Pulse
• Frequency
• Switch Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module. • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
• 20-21 (I/O 4) –
Signal mode – Select the signal mode for the
PFS output. • Passive
• Active
• Passive NAMUR Passive
Assign frequency output The Frequency option is
selected in the Operating
mode parameter (→  125).
Select process variable for
frequency output. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
Off
Minimum frequency value The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Enter minimum frequency. 0.0 to 10 000.0 Hz 0.0 Hz