Endress+Hauser Proline Promag W 500, Руководство по эксплуатации

Страница: 63 / 262

Proline Promag W 500 PROFINET Electrical connection
Hauser 63
N
ic
h
t
u
n
te
r
ar
e
ö
ffn
e n
+
E
ESC
–
22 mm
24 mm
5.
4.
A0033984
4. Connect the cable in accordance with the terminal assignment .
 Signal cable terminal assignment: The device-specific terminal assignment is
documented on an adhesive label in the terminal cover.
Supply voltage terminal assignment: Adhesive label in the terminal cover or
→  46.
5. Firmly tighten the cable glands.
 This concludes the cable connection process.
6. Close the terminal cover.
7. Fit the display module holder in the electronics compartment.
8. Screw on the connection compartment cover.
9. Secure the securing clamp of the connection compartment cover.
Removing a cable
3 (0.12)
2.
1.
A0029598
 18 Engineering unit mm (in)
1. To remove a cable from the terminal, use a flat-blade screwdriver to push the slot
between the two terminal holes
2. while simultaneously pulling the cable end out of the terminal.