Endress+Hauser Proline Promag W 500, Руководство по эксплуатации

Страница: 175 / 262

Proline Promag W 500 PROFINET Diagnostics and troubleshooting
Hauser 175
LED Color Meaning
Flashing green Device is not configured.
Flashing red A diagnostic event with "Warning" diagnostic
behavior has occurred.
Red A diagnostic event with "Alarm" diagnostic behavior
has occurred.
Flashing red/green The device restarts.
2 Device status (during
start-up) Flashes red slowly If > 30 seconds: problem with the boot loader.
Flashes red quickly If > 30 seconds: compatibility problem when
reading the firmware.
3 Flashing/network status Green Cyclic data exchange is active.
Flashing green Following request from automation system:
Flash frequency: 1 Hz (flash functionality: 500 ms
on, 500 ms off)
Cyclic data exchange is not active, no IP address is
available:
Flash frequency: 3 Hz
Red IP address is available but there is no connection to
the automation system
Flashing red Cyclic data exchange was active but the connection
was disconnected:
Flash frequency: 3 Hz
4 Port 1 active:
PROFINET Off Not connected or no connection established.
White Connected and connection established.
Flashing white Communication not active.
5 Port 2 active:
PROFINET and
service interface (CDI) Off Not connected or no connection established.
Yellow Connected and connection established.
Flashing yellow Communication not active.
12.2.2 Sensor connection housing
Proline 500 – digital
Various light emitting diodes (LED) on the ISEM electronics (Intelligent Sensor Electronic
Module) in the sensor connection housing provide information on the device status.
64
63
61
62
A
B
L-
L+
Communication
Power
Communication
Alarm
Power
1
2
3
A0029699
1 Communication
2 Device status
3 Supply voltage