Endress+Hauser Proline Promag W 500, Руководство по эксплуатации

Страница: 128 / 262

Commissioning Proline Promag W 500 PROFINET
128 Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Maximum frequency value The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Enter maximum frequency. 0.0 to 10 000.0 Hz 10 000.0 Hz
Measuring value at minimum
frequency The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Enter measured value for
minmum frequency. Signed floating-point
number Depends on country
and nominal
diameter
Measuring value at maximum
frequency The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Enter measured value for
maximum frequency. Signed floating-point
number Depends on country
and nominal
diameter
Failure mode The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Define output behavior in
alarm condition. • Actual value
• Defined value
• 0 Hz 0 Hz
Failure frequency The Frequency option is
selected in the Operating
mode parameter (→  125)
and a process variable is
selected in the
Assign
frequency output parameter
(→  127).
Enter frequency output value
in alarm condition. 0.0 to 12 500.0 Hz 0.0 Hz
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings