5-8
Chapter 5. FUNCTIONS
●
●
Time events
When the event 1 to 3 type is set to time event, the event can be used
in the same way as time events 1 to 5. However, note that events 1 to
3 do not have segment No. event functions.
Though the event standby function does not function, the ON delay
function does.
The ON and OFF times or only the ON time can be set for each
event No. and segment.
The following describes ON/OFF of output:
• When the ON time is smaller than the
OFF time, output is ON for the duration
from the ON time to the OFF time.
(See segments 1, 6 and 7 in the figure.)
• When only the ON time is set, output is
ON for the during from the ON time to
the segment end point.
(See segments 2 and 5 in the figure.)
• When both the ON time and OFF time
are not set, output is OFF.
(See segment 3 in the figure.)
• Setting only the OFF time without an
ON time is not possible.
(See segment 3B in the figure.)
• Setting an ON time to be greater to or
equal than the OFF time is not possible.
(See segment 3C in the figure.)
• Only ON and OFF times set within the
segment time are valid. Times strad-
dling the next segment are invalid.
The ON and OFF times set in the next
segment are valid.
(See segments 4 and 5 in the figure.)
Accordingly,
the ON and OFF times
settings at the segment end point are
ignored.
Segment
1
ON time
OFF time
Output ON
Output OFF
ON<OFF
Segment
2
3
ON time
OFF time
Output ON
Output OFF
Output turns OFF at
end of segment even if
OFF time is not set.
Segment
3B
3C
ON time
OFF time
Output ON
Output OFF
No ON
ON=OFF ON>OFF
Segment
4
Segment time
5
ON time
OFF time
Output ON
Output OFF
ON-OFF time is invalid
if set in excess of
segment 4 time.
Advance to
segment 5
