8-20
Chapter 8. PROGRAM SETUP
8 - 2
Copying Programs
The
DCP31
can be set for copying programs in the program operation READY mode in the basic
display state. If the
DCP31
is not in the basic display state, press
DISP
.
■
Operation
(1) Set the
DCP31
to the program operation READY mode.
Set variable parameter
L
O
C
to either of 0, 1 or 3, and variable
parameter
P
R
T
C
to 0.
(2) In the basic display state, press
PROG
or
to select the copy
source program No.
However, note that the program No. cannot be selected on the
console when controlling the
DCP31
by external switch inputs.
For details, see 6-3 Program Selection (page 6-7).
(3) If you press
+
PROG
, “
C
O
P
Y
” is displayed on the upper
display, and the copy destination program No. is displayed on
the lower display.
(4) If you press
or
, currently non-set program Nos. are
displayed blinking in order as the copy destination program No.
When there are no non-set program Nos., “- - - -” is displayed on
the lower display.
(5) If you press
ENT
, program copy is executed, and the lower dis-
play stops blinking. To repeat the procedure, carry out steps (4)
and (5) again.
(6) To quit program copy, press
DISP
.
●
●
Display
Program No.
Output state of events 1 to 3, time events 1 to 5
Copy destination program No.
C
O
P
Y
