8-7
Chapter 8. PROGRAM SETUP
■
Display details
The following figure shows the conventions used for displays in this
manual:
■
Setting up pattern items
(1) In the setting display state, move to the pattern item of the seg-
ment to be set up on the programming map.
(2) If you press
ENT
, the upper display starts blinking to indicate
start of entry to the No.1 setup.
(3) Press
,
,
or
to set to the No.1 setup SP setting.
Setting range: SP1 lower to upper limit
(Set the SP1 limit in setup data
C
0
9
or
C
1
0
.)
(4) When you press
ENT
, blinking on the upper display stops. The
lower display then starts blinking to indicate start of entry to the
No.2 setup.
(5) Press
,
,
or
to set to the No.2 setup time set-
ting.
Setting range: 0:00 to 99:59 (h:min/min:s)
0.0 to 599.9 (0.1 s)
(Select either of h:min or min: s as the time unit in setup data
C
6
4
. “:” is substituted by “.” as it cannot be displayed.)
(6) When you press
ENT
, blinking on the lower display stops.
– – – –
– – – –
: LED lit
Program/Segment No. Display
Basic indicator LED lamps
Program No. Segment No.
Pattern
tendency
Upper display
Lower display
Event LEDs
EV1 to EV3 and T1 to T5 all out
Profile Display
Displays program/segment No. currently being set up.
Decimal point blinks in program setup state.
SP
TM
