8-9
Chapter 8. PROGRAM SETUP
●
●
When event type is time event
(1) In the setting display state, move to the event 1 to 3 items of the
segment to be set up on the programming map.
(2) If you press
ENT
, the upper display starts blinking to indicate
start of entry to the No.1 setup.
(3) Press
,
,
or
to set to the No.1 setup ON time
setting.
Setting range: 0:00 to 99:59 (h:min/min:s)
0.0 to 599.9 (0.1 s)
(Select either of h:min or min:s as the time unit in setup data
C
6
4
. “:” is substituted by “.” as it cannot be displayed.)
(4) When you press
ENT
, blinking on the upper display stops. The
lower display then starts blinking to indicate start of entry to the
No.2 setup.
(When
FUNC
+
CLR
are pressed, the upper and lower displays
both return to “- - - -” and blinking stops.)
(5) Press
,
,
or
to set to the No.2 setup ON time
setting.
Setting range: ON time s 0:01 to 99:59 (h:min/min:s)
ON time s 0.1 to 599.9 (0.1 s)
(6) When you press
ENT
, blinking on the upper display stops.
(When
FUNC
+
CLR
are pressed, the upper display returns to
“- - - -” and stops blinking.)
●
●
Display (time event)
• “- - - -” is displayed for the setting values in non-set segments.
• When setup data
C
6
8
is set to 1, event 1 to 3 items on the pro-
gramming map are all skipped and not displayed.
• When the event type is set to time event and the ON time is set to
99:59, “- - - -” is displayed for the ON time and the display does not
blink. In this case, the OFF time cannot be set.
• When the event type is set to time event and the ON time is set
higher than the time setting of the pattern item, event output at
that segment is OFF. However, note that event output is ON when
ON time setting value
OFF time setting value
Program No. Segment No.
Pattern
tendency
LEDs corresponding to EV1 to EV3 lit. T1 to T5 all out
