ZYGO KMS-310, Supervisor Manual

Page: 279 / 304

KMS-310/400 Supervisor's Manual 8-13
6. Loosen the bottom screw, then lift the heat distributor sink and bulb straight
up and out of the lamp socket (Figure 8-9).
Figure 8-9. KLH Bulb
1
2
1
Bottom screw
2
Heat distributor sink
e
KLH-1 lamp bulb
f
Lamp socket
5
Heat sink screw
e
5
f
7. Set the heat distributor sink down (with the bulb pointing up).
8. Loosen the heat sink screw and gently pull the bulb out.
9. Place the new bulb into the socket with the positive side pointing up.
10. Slide the bulb along the grooves until the bulb nipple is out of the field of
view.
11. Tighten down the heat sink screw.
12. Reinsert the heat distributor sink/bulb assembly back into the lamp socket
housing.
13. Close the lamp housing cover and retighten the two housing screws.
14. Put the lamp housing back on the stand and rotate it clockwise on the lamp
housing stand until tight.
L
Note: The lamp is keyed so that the bottom is larger than the top.
When reinstalling the lamp housing back onto the stand, make sure
the lamp wire is turned to the side.