170 Commissioning
WAGO I/O SYSTEM 750 XTR
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
Table 108: WBM “Configuration of Cloud Connectivity” Page – “Settings” Group
Parameter
Explanation
Key file
Enter the path here to the file encoded in PEM
format that contains the private key for cloud service
authentication.
Data Protocol
Here you can select the data protocol.
Cache mode
Specify here in which memory the cache for the data
telegrams should be created.
This selection field is only enabled if a correctly
formatted SD card is inserted.
(You can find more information in Application Note
A500920.)
Last Will
Here you can specify whether a last will message
should be enabled/disabled.
(Last Will) Topic
Here you can specify the topic under which the last
will messages should be sent.
(Last Will) Message
Here you can enter the message you wish to use as
the last will message.
(Last Will) QoS
Here you can specify the “Quality of Service” (QoS)
of the last will message.
Device info
Specify here whether a device info message should
be generated that informs the cloud service of the
basic configuration of the PFC.
(You can find more information in Application Note
A500920.)
Device status
Specify here whether device state messages should
be generated that inform the cloud service about
changes in the mode selector switch and the LEDs.
(You can find more information in Application Note
A500920.)
Standard commands
Specify here whether the integrated standard
commands should be supported.
(You can find the list of standard commands in
Application Note A500920.)
If the check box is disabled, only the commands
defined in the IEC program are supported.
Click the
[Submit]
button to apply a change.
The changes only take effect after the controller restarts. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
The following table shows the dependencies of the selection and input fields for
the selected cloud platform.
