WAGO I/O SYSTEM 750 XTR
Service 335
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
11.2 Firmware Changes
Obtain documentation appropriate for the firmware target version!
A firmware change can modify, remove or add controller properties and
functions. As a result, described properties or functions of the controller may not
be available or available properties or functions may not be described in the
documentation.
Therefore, use only documentation appropriate for the target firmware after a
firmware change.
If you have any questions, feel free to contact our WAGO Support.
11.2.1 Perform Firmware Upgrade
Do not switch the controller off!
The controller can be damaged by interrupting the upgrade process.
Do not switch the controller off during the upgrade process and do not disconnect
the power supply!
Proceed as follows if you want to upgrade the controller to a later firmware
version:
1.
Save your application and the controller settings.
2.
Switch off the controller.
3.
Insert the memory card with the new firmware image into the memory card
slot.
4.
Switch on the controller.
5.
After booting the controller, launch the WBM “Create Boot Image” page
(you may have to temporarily change the IP address).
6.
Create a new boot image on the internal memory.
7.
Switch off the controller after completing the process.
8.
Remove the memory card.
9.
Switch on the controller.
The controller can now be started with the new firmware version.
