382 Appendix
WAGO I/O SYSTEM 750 XTR
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
Table 287: Description of Configuration Scripts for “SNMP”
Parameters Status Call-Up
Output/Input
Valid
General SNMP information parameters
Name of device
read
get_snmp_data
device-name
Specifies the SNMP parameter
“sysName”.
Right
away
write
config_snmp
device-name=<Value>
Change the SNMP parameter
“sysName”
(<Value> = string).
*
After
restart
Description
read
get_snmp_data
description
Specifies the SNMP parameter
“sysDescr”.
Right
away
write
config_snmp
description=<Value>
Change the SNMP parameter
“sysDescr”
(<Value> = string).
*
After
restart
Physical
location
read
get_snmp_data
physical-location
Specifies the SNMP
“sysLocation” parameter.
Right
away
write
config_snmp
physical-
location=<Value>
Change the SNMP parameter
“sysLocation”
(<Value> = string).
*
After
restart
Contact
read
get_snmp_data
contact
Specifies the SNMP “sysContact”
parameter.
Right
away
write
config_snmp
contact=<Value>
Change the SNMP parameter
“sysContact”
(<Value> = string).
After
restart
*
When entering values, the blank characters must be filled by either “+” or “%20”. If this is not
done, the input is not recognized as a coherent string.
SNMP Manager configuration for v1 and v2c
Protocol status read
get_snmp_data
v1-v2c-state
Outputs the status of the SNMP
protocol for v1/v2c as a string.
Possible return values:
- enabled
- disabled
Right
away
Local
Community
Name
read
get_snmp_data
v1-v2c-community-name
Specifies the community name
set for v1/v2c/
Right
away
Protocol
Status/Commu
nity Name
write
config_snmp
v1-v2c-state=<Value1>
v1-v2c-community-
name=<Value2>
Activates/deactivates the v1/v2c
protocol (<Value1> = enabled or
disabled) and assigns a
community name. (<Value2> =
string without spaces, min. 1,
max. 32 characters).
Note:
No community name is required
for deactivation.
Activation is only possible by
entering a community name. A
community name can only be
saved when the protocol is
activated.
After
restart
