WAGO I/O SYSTEM 750 XTR
Commissioning 187
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
7.8.1.42.8 “Tasks” > “Task n” Submenu
In this submenu, information on the selected task is displayed.
The submenu only appears when CODESYS 2 is enabled as the runtime system.
Table 136: “PLC Runtime” > “Information” > “Tasks” > “Task n” Submenu
Parameters
Explanation
Cycle count
Number of task cycles since the system start
Cycle time (µsec)
Currently measured task cycle time for the task
Cycle time min (µsec)
Minimum task cycle time for the task since the
system start
Cycle time max (µsec)
Maximum task cycle time for the task since the
system start
Cycle time avg (µsec)
Average task cycle time since the system start
Status
Task status (e.g., RUN, STOP)
Mode
Task execution mode (e.g., in cycles)
Priority
Set task priority
Interval (msec)
Set task interval
To return to the higher-level menu, press
[Q]
or
[Return]
.
7.8.1.42.9 “PLC Runtime” > “General Configuration” Submenu
This submenu contains other submenus with general settings for the runtime
system.
Table 137: “PLC Runtime” > “General Configuration” Submenu
Menu Item
Explanation
0. Back to …
Back to the higher-level menu
1. PLC Runtime Version
Opens a submenu for the CODESYS runtime
system settings
2. Home Dir On SD Card
Opens a submenu for the home directory settings
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press
[Q]
.
