110 Commissioning
WAGO I/O SYSTEM 750 XTR
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
6.
Select the “Network” tab:
Figure 42: “WAGO Ethernet Settings” – “Network” Tab
7.
To assign a fixed address, select “Static configuration” on the “Source” line
under “Input”. DHCP is normally activated as the default setting.
8.
In the column “Input” enter the required IP address and, if applicable, the
address of the subnet mask and of the gateway.
9.
Click on
[Write]
to accept the address in the controller. (If necessary,
“WAGO Ethernet Settings” will restart your controller. This action may
require about 30 seconds.)
10. You can now close “WAGO Ethernet Settings”, or make other changes
directly in the Web-based Management system as required. To do this,
click on
[Run WBM]
at the right in the window.
