204 Commissioning
WAGO I/O SYSTEM 750 XTR
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
7.8.1.44.7 “User Filter” > “Add New / No (n)” Submenu
In this submenu, you can create, change or delete filter entries.
Table 163: “Firewall” > “User Filter” > “Add New / No (n)” Submenu
Menu Item
Submenu Item / Explanation
0. Back to …
Back to the higher-level menu
1. Policy
Select here whether the network devices is to be
allowed or excluded by the filter.
0. Back to … Back to the higher-level menu
1. Allow
The network device is permitted.
2. Drop
The network device is excluded.
2. Source IP address
Enter the source IP address.
3. Source netmask
Enter the source network mask.
4. Source port
Enter the source port number.
5. Destination IP address
Enter the destination IP address.
6. Destination netmask
Enter here the destination netmask.
7. destination port
Enter the destination port number.
8. protocol
Select the permitted protocols.
0. Back to … Back to the higher-level menu
1. tcp
The TCP protocol is permitted.
2. udp
The UDP protocol is permitted.
3. tcp & udp Both protocols are permitted.
9. interface
Select the permitted interfaces.
0. Back to … Back to the higher-level menu
1. all
All interfaces are permitted.
2. VPN
The VPN interface is permitted.
3. WAN
The WAN interface is permitted.
4. X1
The X1 interface is permitted.
5. X2
The X2 interface is permitted.
10. state
Enable or disable the filter.
0. Back to … Back to the higher-level menu
1. on
The filter is enabled.
2. off
The filter is disabled.
11. accept
To apply the changes for the selected filter entry,
choose this menu item.
12. delete
To delete the selected filter entry, choose this menu
item.
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press
[Q]
.
Click
[<OK>]
to apply the entry.
Click
[<Abort>]
to discard the entry.
