WHEEL FREENESS
Inspect at initial 500 - 750 km and every
3000 km thereafter.
l
Slowly rotate both the wheels by hand and
observe for any abnormal noise / tightness.
(Fig. 2.116)
l
If found any, inspect for the proper functioning
of brakes. If found OK then, inspect for the
proper play in the drive chain (refer page no.
2-32). Also inspect for correctness of wheel
bearing, alloy wheel etc., (refer chapter
“Chassis“ page no. 6-1 & 6-28 for removal and
inspection procedure).
Note:
Tight wheel rotation increases fuel
consumption.
TYRES
Inspect at initial 500 - 750 km and at every
3000 km thereafter
.
Tyre tread condition:
l
Using the vehicle with excessively worn tyres
will decrease riding stability and consequently
invite a dangerous situation due to loss of
control. It is highly recommended to replace
the tyre with a new one when the groove
depth of tyre from tread surface reaches the
following specifications: (Fig. 2.117)
Service limit
Front
1.5 mm
Rear
1.5 mm
Tyre depth gauge
Note:
Tyre depth also can be checked by tyre
wear indicator. (Fig. 2.118)
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
2-43
Fig. 2.116
Fig. 2.117
Tyre depth
Fig. 2.118
