l
Loosen and adjust the chain adjusting bolts (A
and B) ‘in’ or ‘out’ equally by looking at the line
mark (C and D) on chain adjusters until the
specified play (slackness) is obtained.
(Fig. 2.88 A & B)
12 mm spanner
Caution:
Adjust both the chain adjuster exactly the
same amount to maintain correct wheel
alignment
l
After obtaining the specified play, rotate the
rear wheel by hand and apply rear brake.
l
Hold the brake pedal in applied condition and
tighten the rear axle nut to the specified
torque.
l
Now, tighten the chain adjusting bolts (A and
B). (Fig. 2.88 A & B)
l
Using TRU SPRAY lubricate the chain while
rotating the wheel slowly. (Fig. 2.89)
Note:
Shake TRU SPRAY container well before
use. Attach the extension tube to the TRU
SPRAY container for pin point application.
Hold the container upright and spray from
a distance of 4-6 inches as shown in the
figure.
l
If dirt / dust particles deposition on the drive
chain is found more, it is recommended for the
first time alone to follow the procedure given
below:
l
Remove the seats and cover frame assembly
as explained earlier.
l
Remove the hexagonal bolt (M6x20) from the
gear shift linkage assembly and dislocate the
gear shift linkage from the shaft gear shift.
(Fig. 2.90)
10 mm spanner
Tightening torque
12 ± 2 Nm
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
2-33
Fig. 2.88A
Fig. 2.88B
A
B
D
C
Fig. 2.89
Fig. 2.90
