Fig. 2.69
l
Measure the free play at the lever assembly
clutch end as shown in the figure, before the
clutch begins to disengage. (Fig. 2.68)
Free play
8 ~ 15 mm
l
If the play is more or less, loosen the lock nut
(A) and turn the adjusting nut (B) ‘in’ or ‘out’
until the specified play is obtained. And then
tighten the lock nut (A), while holding the
adjusting nut (B) in the same position.
(Fig. 2.69)
12 mm spanner
Note:
Adjust the clutch play when the engine is
in cold condition
CABLE ASSEMBLY THROTTLE - FREE PLAY
Inspect, adjust and lubricate ends with
grease at initial 500 - 750 km and every
3000 km there after
l
For checking the cable assembly throttle
(throttle cable) free play, first dislocate the boot
throttle (A) from its position. (Fig. 2.70)
l
Gently pull the throttle cable while holding the
adjuster (A) to check the free play. (Fig. 2.71) If
the free play is more or less adjust as follow:
Free play
1 ~ 2 mm
l
Loosen the lock nut (B) and turn the adjuster
(A) ‘in’ or ‘out’ until the specified play is
obtained.
10 mm / 8 mm spanner
l
Tighten the lock nut (B) while holding the
adjuster (A) in place.
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
2-26
Fig. 2.68
8 ~ 15 mm
A
B
Fig. 2.70
Fig. 2.71
A
A
B
