l
After adjusting, start the vehicle, let the engine
run in idle, turn the handle bar to extreme right,
left and check whether idling rpm varies. If it
varies check the routing of throttle cable and if
required correct it. Readjust the free play once
again.
l
The throttle cable also can be adjusted at the
carburettor end. Follow the procedure to adjust
the play.
l
Measure the throttle cable free play as
explained earlier.
l
If the measured free play is more or less,
loosen the lock nut (A) and turn the adjuster nut
(B) ‘in’ or ‘out’ until the specified play is
obtained. And then tighten the lock nut (A),
while holding the cable adjuster (C). (Fig. 2.72)
10 mm spanner
THROTTLE GRIP
Lubricate with grease every 6000 km.
l
Inspect throttle grip for smooth rotation. If
found hard remove and lubricate as explained
below:
l
Remove the throttle cable locking screw from
throttle case lower. (Fig. 2.73)
Phillips head screw driver
Tightening torque
2.25 ± 0.25 Nm
l
Remove the CRR pan head screws (M5x30
2 nos.) from the throttle case upper and lower
mounting. (Fig. 2.74)
Phillips head screw driver
Tightening torque
1.75 ± 0.25 Nm
l
Gently dislocate the throttle case upper and
lower. Disconnect the throttle cable from grip
complete throttle.
2-27
TVS APACHE RTR 200
SERVICE MANUAL
PERIODIC MAINTENANCE
Fig. 2.72
A C
B
Fig. 2.73
Fig. 2.74
