Fig. 3.178
l
When fixing the oilseal over the shaft check
that the lip seats over the shaft perfectly all
around the circumference without any
distortion.
l
Apply engine oil on each running and sliding
part before installing them during reassembly.
Fasteners
l
Tighten all fasteners to the specified torque
using torque wrench (refer torque chart in page
no. 7-8 & 7-9 for torque specification).
C R A N K C A S E A S S E M B L Y L H & R H -
REASSEMBLY
l
Remove the gasket material on the mating
surfaces of crankcase assembly L & R and
thoroughly remove oil stains.
l
Assemble the idle gear on the crankcase
assembly LH and secure it with the bracket idle
gear using hexagonal flange bolt (M6x16) and
tighten it to the specified torque. (Fig. 3.178)
8 mm spanner
Tightening torque
10 ± 2 Nm
l
Assemble the balancer shaft complete as an
assembly in the crankcase assembly LH.
(Fig. 3.179)
l
Rotate the balancer shaft to other side as
shown and assemble the crankshaft assembly
in the crankcase assembly LH. (Fig. 3.180)
Note:
While assembling the crankshaft take
extra care not to cause any dent, damage
and scratches to the machined surfaces.
3-53
Fig. 3.179
Fig. 3.180
TVS APACHE RTR 200
SERVICE MANUAL
SERVICING OF ENGINE
