l
Take out the idler gear along with shims
(11.2x18.5x1 - 2 nos.). (Fig. 3.156)
Note:
While reassembling the idler gear ensure
the presence of shims on both side.
l
Using the special tool, remove the ball bearing
(6207) from the crankshaft assembly (in case if
t h e b e a r i n g c o m e s w i t h c r a n k s h a f t ) .
(Fig. 3.157)
S131 111 0
Extractor main bearing
17 mm spanner
l
Using the special tool (bearings installer set),
bearings and oil seals can be removed and
reassembled. (Fig. 3.158)
S131 050 0
Bearing installer set
Metal hammer
Note:
Remove the bearings, only if they need to
be replaced. Unnecessary removal of
bearings should be avoided, otherwise can
damage the bearings and can cause
deterioration to the interference fit. It is
sufficient to clean and lubricate the
bearings in assembled condition.
l
Using the special tool (universal oil seal
remover), the oil seals can removed.
(Fig. 3.159)
031 240 1
Universal oil seal remover
TVS APACHE RTR 200
SERVICE MANUAL
SERVICING OF ENGINE
3-45
Fig. 3.156
Fig. 3.157
Fig. 3.158
Fig. 3.159
