l
Remove the hexagonal flange bolt (M6x16 -
2 nos.) from the bottom mounting housing
head lamp (both LH and RH) while holding the
housing by one hand. (Fig. 6.67)
10 mm spanner
Tightening torque
3 ± 1 Nm
l
Take out the housing head lamp by gently
disconnecting and dislocating the wiring
sockets of main wiring harness.
l
Remove both the leg assembly front fork (refer
page no. 6-17).
l
Take out cap lock nut (A) and remove lock nut
steering along with the special washer.
(Fig. 6.68)
32 mm spanner
Tightening torque
80 ± 20 Nm
l
Gently lift the handle bar assembly, support
and hang it at the side of the fuel tank complete
while taking care of painted surface of the tank.
Note:
Ensure that the control cables are not
stretched too much or bent.
l
Unlock the lock washer arrester steering using
a blunt tool. (Fig. 6.69A)
l
Remove the arrester steering stem top using a
special tool. (Fig. 6.69B)
N931 014 0
Tool steering nut
l
Take out the lock washer arrester steering.
(Fig. 6.70A)
l
Remove the arrester steering stem using the
special tool while holding the lower bracket
complete and draw out bracket. (Fig. 6.70B)
N931 014 0
Tool steering nut
Note:
Steering balls tend to fall during bracket
removal, hence they should be collected
carefully.
TVS APACHE RTR 200
SERVICE MANUAL
CHASSIS
6-24
Fig. 6.67
Fig. 6.68
A
Fig. 6.69A
Fig. 6.69B
Fig. 6.70A
Fig. 6.70B
