l
Disconnect both the thermel from the battery
assembly. (Fig. 3.120)
l
Dislocate the boot (A) from the starter motor
terminal. (Fig. 3.121A)
l
Remove the special screw (B) along with
washer from the starter motor positive
terminal and disconnect positive terminal.
(Fig. 3.121B)
8 mm spanner
Tightening torque
10 ± 2 Nm
l
Remove the hexagonal flange bolt (M6x25 -
1 no.) (C) from the starter motor mounting and
remove the negative terminal from the starter
motor. (Fig. 3.121B)
8 mm spanner
Tightening torque
10 ± 2 Nm
l
Dislocate the hose clip (A) and disconnect the
hose breather PCV (B) from the engine
assembly. (Fig. 3.122)
Nose plier
l
Remove the hexagonal flange bolt (M6x25 -
1 no.) from pipe complete inlet of engine oil
cooler and dislocate the pipe complete inlet
from the crank case assembly R. (Fig. 3.123)
8 mm spanner
Tightening torque
10 ± 2 Nm
Note:
An ‘O’ ring is fitted on the pipe complete
inlet end. Ensure the condition and
availability of ‘O’ ring during reassembly.
Fig. 3.120
Fig. 3.121A
Fig. 3.121B
Fig. 3.122
Fig. 3.123
TVS APACHE RTR 200
SERVICE MANUAL
SERVICING OF ENGINE
3-36
A
A
B
B
C
